Texecom RS232 - Google Groups
Sep 11, 2019 · I could then cut the VGA in half and connect the correct wires to the loxone extension inputs. If that will work, does any one know what the pinouts are on the PC-Com cable and would these be the same as the standard pinouts for female RS-232 e.g in the attached drawing I should be using pins 2,3&5.
foot switch PTT pinout or cable question - Google Groups
Oct 1, 2023 · You could do it with one of these (eBay link below) and use one of the 1/4" sockets to plug in your footswitch the one that goes to RING (mono socket on the adapter should be labelled RIGHT) for PTT and the other one (mono socket should be labelled LEFT) to plug in a CW key that goes to the TIP for the CW key, and then a simple lightweight 3 ...
Ayuda pinout pantalla banghó - Google Groups
Según la datasheet de HannStar HSD100IFW1-A00 tiene 30 pines en el conector, pero, la vida nunca es fácil y la pantalla en sí tiene 32 pines y en parte por mirando el ancho de las pistas y en parte con continuidad, hay además un desplazamiento en algún lado, observando dónde están gnd, 3.3v y 5v se vé que el mapeo es muy similar.
9pin RGB pinout to 15pin RGB pinout cable? - Google Groups
All groups and messages ... ...
Connecting Signalink USB to FTM-400. - Google Groups
Oct 3, 2021 · I found that site. This is the pinout for my FTM-400XDR. It also states I need two Yaesu cables. One cable (SLUSB6PM) is available at RadioWorld and the other (CT-164) I need to have shipped from DX Engineering. Total cost would be about $100. That is about what I paid for the Signalink. There is no RJ54 to 10-pin Mini DIN cable.
Hermes-Lite 2.0 Getting Started - Google Groups
Jan 20, 2018 · 1. Have not managed to get it running with a direct LAN cable connection between the H-L and the PC. Works fine with the H-L connected to a router via wi-fi. When it's directly connected a network address of 169.254.37.109 shows up in ipconfig /all (Windows 10). When I put this address into Quisk though it doesn't connect.
Radioberry preamp board where to buy? - Google Groups
Jul 25, 2021 · Wonderful! thank you! :) I am waiting for a reply from maker fabs, and i forwarded this on to them. They wanted to make sure i was authorized, haha i told them it was open hardware!!!
IO board and Pure Signal - Google Groups
Sep 23, 2023 · I noticed when using the new I/O Board and pure signal, the Theits A-ATT value when transmitting is only "6". When using by other Hermes without the I/O board with the sma jumper coax soldered onto the header pins, it has a much higher ATT value of
Blower Motor Wiring (colors) - Google Groups
Jul 28, 1999 · Black is High speed/Cooling speed and the Fan ON continuous speed. a motor will work with either leg of power on common, on 230 v motors 2 hot legs are used, regardless the Common terminal and Run winding get the power.
N2ADR + Radioberry?? - Google Groups
Jan 17, 2022 · Looking to build my own transceiver and so far I have receive working fine. I'm not using the juice board but am about to purchase the N2ADR filter board.